Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Outlet
Pressure .....
2050 psi
Flow Rate ..........
2.0 gallons per minute (gpm)
Detergent
..........
Use detergent approved for
pressure washers
Water Supply
......
Not to Exceed 100°F
Temperature
Automatic Cool
.... Willcyclewhen water
Down System
reaches 125°-155°F
ShippingWeight
.... 48 Ibs.
GENERAL
MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator
abuse or negEgence.To
receive full value from the warranty, the operator
must
maintain the pressure washer as instructed in this manual
• Some adjustments witl need to be made periodically to
properly
maintain your pressure washer.
• All maintenance in this manual and the engine owner's
manual should be made at least once each season.
• Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun
and adjustable nozzle extension assembly for wear.A
new spark plug and clean air filter assure proper fuel-air
mixture
and help your engine run better
and last longer.
Please refer to your engine owner's manual for more
details.
• If equipped with inflatabletires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before
Each Use
I.
Check engine oil level.
2.
Check water inlet screen for damage.
3.
Check in-line filter for damage.
4.
Check high pressure hose for leaks.
5.
Check chemical injection hose and filter for damage.
6.
Check spray gun and adjustable nozzle extension
assembly for leaks.
7.
Rinse out garden hose to flush out debris.
PRESSURE WASH ER
MAINTENANCE
Check
and Clean
Inlet Screen
Examinethe screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check
High
Pressure
Hose
The high pressure hose can develop leaksfrom wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks,abrasions or bulging of cover,
damageor movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement
hose rating MUST exceed maximum
pressure
rating of unit.
Check
Chemical
Injection
Hose
Examinethe filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check
Gun and Adjustable
Nozzle
Extension
Examinethe hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the safety latch in the ON position and test the trigger.You
should not be able to press the trigger.
Purge Pump of Air and
Contaminants
To remove air from the pump, follow these steps:
I.
Set up pressure washer as described in"Preparing
PressureWasher For Use". Connect water supply and
turn
water
on.
I
II
Publicidad
