Publicidad
Idiomas disponibles
Idiomas disponibles
CleanShot
TM
2050 PSI PressureWasher
Connect
Hose and Water
Supply to
Pump
IHPORTANT:
To avoid pump damage,you must assemble
the nozzle extension to the spray gun and attach atl hoses
before you start the engine.
I.
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure I).Tighten by hand.
Connect high pressure
hose here
NOTE: Remove and discard alt pump shipping caps before
attaching hoses.
2.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 2).Tighten by hand.
4.
Run water through your garden hose for 30 seconds
to clean out any debris.
IMPORTANT:
DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than IO0°E).
5.
Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tightenby hand (Figure 3).
CAUTION
• Damage to equipment
resulting from failure to follow this
instruction will voidwarranty.
6.
Turn ON the water and squeeze the trigger on the
gun to purge the pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
.
Before connectinggarden hose to water inlet, inspect
inlet screen (Figure 3). Clean screen if it contains
debris or have it replaced if damaged.DO NOT RUN
PRESSUREWASHER IF INLET SCREEN IS DAMAGED.
Inspectintet
screen, DONOT
use if damaged;
clean if dirty.
CHECKLIST
BEFORE
STARTING
ENGINE
Review the unit's assembly to ensure you have performed
alt of the following.
I.
Check that oit has been added to proper level in the
engine crankcase.
2.
Add proper gasoline to fuel tank.
3.
Check for properly tightened hose connections.
4.
Check to make sure there are no kinks, cuts, or
damageto high pressure hose.
5.
Provide a proper water supply at an adequate flow.
6.
Be sure to read "Safety Rules" and "HowTo UseYour
PressureWasher" before using pressure washer.
/
7
Publicidad
