Cleaning And Care; Interior - After Microwave Cooking; Odor Removal - Viking Range VMDD5306SS Manual De Uso Y Cuidado

Horno microondas con convección/velocidad
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning and Care

Disconnect the power cord before cleaning or leave the
door open to inactivate the oven during cleaning.
EXTERIOR
The outside surface is precoated metal and plastic. Clean
the outside with mild soap and water; rinse and dry with a
soft cloth. Do not use any type of household or abrasive
cleaner.
DOOR
Wipe the window on both sides with a damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a damp cloth. Avoid the
use of spray and other harsh cleaners as they may stain,
streak or dull the door surface.
TOUCH CONTROL PANEL
Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened
slightly with water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close door and touch
STOP/CLEAR pad.
INTERIOR - AFTER MICROWAVE
COOKING
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe
with a soft cloth and warm water. DO NOT USE ABRASIVE
OR HARSH CLEANERS OR SCOURING PADS. For heavier
soil, use baking soda or a mild soap; rinse thoroughly with
hot water. NEVER SPRAY OVEN CLEANERS DIRECTLY
ONTO ANY PART OF THE Oven.
INTERIOR - AFTER CONVECTION,
SPEED BAKE OR SPEED ROAST
Spatters may occur because of moisture and grease.
Wash immediately after use with hot, soapy water. Rinse
and polish dry. Harder to remove spatters may occur if
oven is not thoroughly cleaned or if there is long time/
high temperature cooking. If so, you may wish to purchase
an oven cleaner pad with liquid cleaner within it—not a
soap filled steel pad—for use on stainless or porcelain
surfaces. Follow manufacturer's directions carefully and be
especially cautious not to get any of the liquid cleaner in
the perforations on the wall or ceiling or any door surfaces.
Rinse thoroughly and polish dry.
After cleaning the interior thoroughly, residual grease may
be removed from the interior ducts and heater by simply
operating the oven on 450˚F for 20 minutes without food.
Ventilate the room if necessary.
E
WAVEGUIDE COVER
The waveguide cover is made from mica so it requires
special care. Keep the waveguide cover clean to assure
good oven performance. Carefully wipe with a damp
cloth any food spatters from the surface of the cover
immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. Do not
remove the waveguide cover.

ODOR REMOVAL

Occasionally, a cooking odor may remain in the oven. To
remove, combine 1 cup water, grated peel and juice of 1
lemon and several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power. Allow
to set in oven until cool. Wipe interior with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable, turntable support and racks can be
removed for easy cleaning. Wash them in mild, sudsy
water; for stubborn stains use a mild cleanser and a non-
abrasive scouring sponge. They are also dishwasher-proof.
Use top rack of dishwasher for turntable support.
Foods with high acidity, such as tomatoes or lemons, will
cause the porcelain enamel turntable to discolor. Do not
cook highly acidic foods directly on the turntable; if spills
occur, wipe up immediately.
The turntable motor shaft is not sealed, so excess water
or spills should not be allowed to stand in this area.
26
26
26
26
26
26
E
E
E
E E E

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido