Additional Middle Position - FAAC TM2 ERY Manual De Usario

The additional middle position is useful to open the awning automatically through
the TM2 X SW sensor and to bring it to a middle position when the light of the en-
vironment exceeds the threshold set. This additional middle position can be used
only in combination with the light automatism of the TM2 X SW sensor.
The awning cannot be brought to this position with the remote control.
However, there is the possibility to program the current middle position using the B button
(2 sec) command. If the additional middle position is not memorized, the light auto-
matism of the TM2 X SW sensor (when enabled) opens the awning completely. When
the TM2 X SW (Set button) sensor is tested, the movements of the motor do not take
the additional middle position into consideration: the awning always stops in the
half-way position and opens completely if the light exceeds the threshold value.
SETTING THE ADDITIONAL MIDDLE POSITION
After saving the limit switches, carry out the following command sequence:
Tn: Already programmed remote control
+
B C
Tn
Starting from this moment, the motor moves in the "dead man" mode. This makes
it possible to regulate the additional middle position in a precise way.
Carry out the following operations:
• Bring the awning to the desired open position.
• Press the B button of the remote control for about 2 seconds, until the motor gives
a confirmation signal.
up
down
Starting from this moment, when the TM2 X SW commands the opening of the
awning through the light automatism (if this is enabled), the awning will be brought
to the additional middle position.
TM2 ERY
SPECIAL FUNCTIONS

ADDITIONAL MIDDLE POSITION

B
Tn
B
Tn (2 sec)
34
B
Tn (2 sec)
A4518_6G40_Rev.A