Assemble As A Blower - sunjoe 24V-X2-BVM190-CT Manual Del Operador

IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to the
batteries.
6. When charging is complete, remove the batteries from
the charger by pulling the push lock button and sliding
the batteries backward to unlock it from the charger.
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not insert batteries until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the batteries are removed from the tool. Failure to heed
this warning could result in serious personal injury.
m
WARNING!
To prevent serious personal injury, make
sure the switch is in the OFF (O) position, the batteries are
disconnected and the impeller has come to a complete stop
before attaching or removing tubes.

Assemble as a Blower

1. Slide the rear blower tube forward until the tube releasing
button on the motor housing clicks into the slot on the
blower tube (Fig. 4).
2. Slide the front blower tube onto the rear blower tube until
the locking tab on the rear blower tube clicks into the slot
on the front blower tube (Fig. 4).
NOTE: The front blower tube is equipped with a
concentrator nozzle, which is used to increase air flow in
tight areas (i.e around flower beds, under decks, etc.).
Fig. 4
Tube releasing
button
Front Rear blower
blower tube
tube
Locking tab
Concentration nozzle
3. Before using the blower function, securely fasten the inlet
cover over the air inlet by closing the inlet cover until the
lock button clicks and locks (Fig. 5).
Fig. 5
4. To remove the blower tube, turn the ON/OFF power switch
to the OFF (O) position and remove both the batteries.
5. Press the tube release button and remove the blower tube
(Fig. 6).
Assemble as a Vacuum/Mulcher
1. Slide the front and rear vacuum/mulcher tubes together
until the locking tabs on both sides engages (Fig. 7).
Fig. 7
Front vacuum tube
2. Press inlet cover lock button forward to disengage the
inlet cover. Hold the cover open (Fig. 8).
10
Inlet cover
lock button
Inlet cover
Fig. 6
Tube releasing
button
Blower tube
Locking tab
Rear vacuum tube