Manual Breastpump Assembly - Medela symphony Instrucciones

7. Assembly of Pump Kit - Lactina
T Tip
Carry out all the steps with care and
assemble the pump kit correctly for
optimum performance.
Parts Needed:
• Breastshield
• Breastmilk bottles/container
• Lid
• Connector
• Valve
• Membrane
• Piston
• Cylinder
Note
• Use Authentic Medela Spare Parts
only. See page 5 for details.
• Check pump kit components for
wear or damage before use and
replace if necessary.
• All components must be completely
dry before use for proper
performance and to prevent
damage to the pump.
24
(cont.)
®
7C. Manual Breastpump Assembly
For manual breastpumping follow the
instructions below.
1
Cylinder Piston
Slide the vacuum regulator
ring onto the cylinder. Push
handle end of piston into the
cylinder.
4
Push yellow valve onto inner
ring of connector bottom.
7
Set vacuum regulator ring to
"MIN".
2
Securely attach breastshield
to connector.
5
Screw connector onto the bottle/
container.
8
Center breastshield
over your nipple and start
pumping by pushing and
pulling on the piston end.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3
Snap membrane onto
yellow valve until membrane
lies fl at.
6
Screw cylinder into back of
breastshield.
8
When your pumping session
is over, store your breastmilk
and refer to section 9. Refer
to sections 3-6 for cleaning
instructions.
25