Operation; Stand Alone Operation; Master Slave Operation; Dmx Controlled Operation - Mark SIDIUS LED 80 Instrucciones De Usuario

The earth has to be connected. The device must only be connected with an electric installation carried
out in compliance with IEC standards.

OPERATION

After you connected the effect to the mains, The fixture starts running

Stand Alone operation

In the stand alone mode, the fixture can be use without controller
Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one
master-device

DMX controlled operation

You can control the projectors individually via your DMX-controller

Addressing

The control board allows you to assign the DMX starting address,
Note;it's necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.
C ONT R O L B O AR D
The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
the main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by
pressing Up or Down .Press the Enter-button in order to select the desired menu. You can change the
selection by pressing Up or Down, Confirm every selection by pressing the Enter-button. You can leave
every mode by pressing the Mode/Esc-button .The functions provided are described in the following
setting.
M EN U M AP
The device has two operation modes, It can be operated in Stand Alone or in DMX controlled
Mode
DMX address
Channel mode
X reverse
Y reverse
XY exchange
XY encoder
Screen mode
Version
SIDIUS LED 80
DMX
Auto 1 /Auto 2 Auto 3 /Auto 4
XY effect 1/ XY effect 2 / XY effect 3 /XY effect 4
Random effect /Sound
Setting DMX address from 001-512
Select 15 or 19 DMX channel
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON display no light after 30 seconds
OFF display light always on
Software version/DMX channel/run time/Total use time
User Manual/Manual de uso Pag 4
EN