Lcd Touch Panel - Phcbi MCO-230AIC Instrucciones De Operación

INCUBATOR COMPONENTS

LCD touch panel

The following display (called the Top screen) will appear when the power switch is turned ON.
Note: It takes approximately 20 seconds until the Top screen is displayed. During warming-up, "Status:
Gas sensor initializing" is displayed in the Message display field (13), and "--.-" is displayed in the present
CO density display field (4).
2
3
1
1. Present temperature display field
The current chamber temperature is displayed.
2. Set temperature value display field
The set value of chamber temperature is
displayed. Default setting: 37
3. Heating indicator
This lights up when the heater is on.
4. Present CO density display field
2
The current chamber CO
Nothing is displayed when CO
0 %.
5. Set CO density value display field
2
The set value of the chamber CO
displayed. Default setting: 0 %.
* Only displayed when optional component MCO-21GC (gas auto-changer) is installed.
14
2
o
C
density is displayed.
2
density is set to
2
density is
2
6 7
6. CO gas injection indicator
2
This lights up when CO gas is being injected.
2
7. CO gas supply line indicator A and B*
2
Current supplying CO
(connecting port for CO
2
When the CO gas automatic changer function
2
changes the empty CO
2
other, the empty indicator is displayed in reverse
video and blinks.
8. CO gas supply line select key*
2
This key selects CO gas supply line A or B
2
(connecting port A or B for CO
an optional gas auto-changer MCO-21GC is
installed, CO gas supply line A/B changes over
2
automatically when CO gas cylinder is empty.
2
8
gas supply line
2
gas pipe) is displayed.
gas cylinder to the
gas pipe). When
2
5
4