Installation - Assembly - Kospel EPO2 Manual Del Usuario

Installation – Assembly
Installation with the outlet and
inlet pipes on the bottom.
Installation with the outlet and
inlet pipes on the top.
EPO.2 - 3,5
EPO.2 - 4,4
EPO.2 - 5,5/6
16
1. Install the water system pipes and electric
supply cables in accordance with the relevant
regulations.
2. Take off the unit's cover: undo the screws, slide
the cover off starting from the inlet and outlet
side.
3. Fix the unit in vertical position with the inlet
and outlet on the top, or on the bottom, as in
the picture.
4. Connect (e.g. using flexible hoses) cold water
to the inlet pipe inserting a filter in between and
connect hot water to the outlet pipe.
5. Open the cold water valve and check for leaks.
6. Vent the installation according to the „Venting"
section.
7. Connect the unit to electric installation in
accordance with markings, tighten cable clamp
to secure cable from slipping.
8. Put the unit's cover back.
9. Make sure that there is no access to live parts
through the holes at the back plate.
flow restriction insert
black 1,9 l/min.
green 2,5 l/min.
violet 3,4 l/min