Pilot ignition
Press and turn the knob to position "
•
Press the knob down fully and light the pilot using the
piezoelectric igniter.
•
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
•
The pilot flame can be seen through the peep hole,
visible when the grease collection tray is removed.
•
The pilot burner can be lit with a flame; for access,
remove the grease collection tray.
Main burner ignition
•
Turn the knob to the desired cooking temperature.
Switching off
To switch the main burner off, turn the knob to position "
To switch off the pilot flame, press and turn the knob to
position "
".
USING THE GAS FRY-TOP WITH VALVE
REMINDERS FOR USE
•
The appliance is designed for cooking foods directly
on the hotplate ( steaks, hamburgers, fish,
vegetables, etc.).
•
The hotplate must not be used to heat pans or
saucepans.
•
Take particular care when using the chromed fry-top.
Always clean the cooking surface and remove any
food residues immediately after cooking. While
cooking, handle food only with the special scraper for
the smooth fry-top or the toothed scraped for the
ribbed fry-top. Do not use sharp or pointed utensils,
which could scrape or damage the chromed surface.
•
The appliance is equipped with a manual reset safety
ther-mostat which interrupts heating when the
operating tempera-ture exceeds the maximum
permitted value.
•
Empty the grease collection tray several times a day.
•
Exercise great caution when removing the tray.
DANGER of scalding from hot oil.
BURNER IGNITION AND EXTINCTION
The control knob for the thermostatic valve has the following
positions:
Off
Pilot ignition
90 Minimum temperature of cooking
280 Maximum temperature of cooking
Instructions for use
".
".
Pilot ignition
Press and turn the knob to position "
•
Press the knob down fully and light the pilot using the
piezo-electric igniter.
•
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
•
The pilot flame can be seen through the peep hole,
visible when the grease collection tray is removed.
•
The pilot burner can be lit with a flame; for access,
remove the grease collection tray.
Main burner ignition
•
Turn the knob to the chosen temperature setting for
cooking.
Switching off
To switch the main burner off, turn the knob to position "
To switch off the pilot lame, press and turn the knob to position
"
".
14. PROLONGED DISUSE
Before any prolonged disuse of the appliance, proceed
as follows:
•
Clean the appliance thoroughly.
•
Rub stainless steel surfaces with a cloth soaked in
Vaseline oil to create a protective film.
•
Leave lids open.
•
Close the valves and turn off the electrical power supply
at the main switch.
Following prolonged disuse, proceed as follows:
•
Inspect the appliance thoroughly before using it again.
•
Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
".
".
27