How To Install Your Canopy Housing; How To Assemble Your Fan Blade And Light Bulbs - Fanimation KLOUT FP3070 Serie Manual De Instrucciones

How to Install Your Canopy Housing

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Fan Blade and Light Bulbs

1. Slide the blade onto the motor assembly shaft and
secure with hairpin clip and blade holder trim cover.
(Figure 1)
CAUTION
Do not connect fan blade until the fan is completely
installed. Installing the fan with blade assembled
may result in damage to the fan blade.
WARNING
To reduce the risk of personal injury, do not bend the
blade when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blade.
2.
Install LED light bulbs into sockets by threading in a
clockwise direction. (Figure 2)
NOTE: When relamping is required, USE ONLY
MAX 6W, TYPE T45 DIMMABLE LISTED LED
(LIGHT) BULB.
CAUTION
RISK OF FIRE. USE ONLY LED LAMPS IN THIS LIGHT
KIT. INCANDESCENT AND HALOGEN LAMPS MAY
CAUSE SEVERE THERMAL DAMAGE.
3. Remove the five screws from the upper grill
assembly and retain the screws. (Figure 3)
Blade
Blade Holder
Trim Cover
Upper Grill
Assembly
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Hairpin Clip
Figure 1
LED
Bulbs (5)
Figure 2
Screws (5)
Figure 3