Product Specifications - Homewerks 3010-501-CH Guia De Inicio Rapido

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. flow rate: 2.5 GPM (9.5 LPM) at 80 PSI
ASME A112.18.1/CSA B125
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main
water supply, disconnect the
supply line, and remove old tub
and shower.
Clean and dry surface area where
new tub and shower will be
mounted.
2. Cover all male threads with PTFE
pipe tape (wrapped clockwise)
or pipe thread compound.
3. Check that flat side of attached
sealing gasket (3.1) faces wall.
Insert tub faucet body (A) into
wall.
4. Install mounting washer (4.1)
(not included) onto tub faucet
body (A) from behind the wall,
then tighten mounting nuts (C).
www.homewerksww.com
1
2
3
3. 1
A
4
SPECIFICATIONS
Easy clean shower head
Tub spout with diverter
Total weight of item: 1.782 lbs.
5. Connect water supply lines (5.1)
(not included) from house to inlet
tubes of tub faucet body (A)
using coupling nut (not included)
and cone washer (not included).
As you face the tub faucet body
(A), hot water should be on your
left, cold water on your right.
Note: Hand tighten the coupling
nuts and then tighten 1/4 turn
with wrench (not included). Do
not overtighten.
6. Connect the tub faucet body
(A) to the appropriate pipe
(not included) that leads to
the shower arm.
7. Install shower arm to the pipe.
Push shower arm flange up
against shower wall.
Note: It is recommended to apply
PTFE pipe tape (D) or pipe
thread compound to threads of
the shower arm for a tight seal.
8. Turn water back on and check for
leaks at supply line connection.
Turn hot (8.2) and cold (8.1)
water on for 30 seconds to
remove debris from the lines.
2
5
5. 1
A
6
A
7
8