Connecting The Battery; Checking/Adding Oil - Pulsar PG4500iSR Manual Del Operador

Connecting the Battery

• Unclip the right side panel
• Put the battery into the square hole beside the recoil
handle
• Slide the battery into the until it clicks into place.
NOTE: The electric start generator is equipped with a
battery charging feature. Once the engine is running, a
small charge is supplied to the battery via the battery
tray and will recharge the battery.
Checking/Adding Engine Oil
• Place generator on a firm level surface.
• Unclip and remove the oil service panel to access
the oil fill/dipstick.
• Remove the crankcase dipstick.
Recommended Oil: SAE 10W-30
Oil Capacity: 0.6L (20.2oz)
• Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of engine oil (SAE 10W-30) to
empty reservoir until or oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
• Be sure to replace dipstick and tighten securely before attempting to start the engine.
• To check oil, set generator on a firm level surface, unscrew and remove dipstick, wipe dipstick clean,
then reinsert dipstick without re-threading.
CAUTION! Generator has been shipped without engine oil. You must add engine oil before operating this
generator. Always check oil level before each operation.
ASSEMBLY
12