Air Filter - Pulsar PG4500iSR Manual Del Operador

Air Filter

A dirty air filter will reduce the life span of the engine, make it difficult to start the engine, and reduce
the unit's performance. Replace with new Air Filter annually.
To clean, remove the screws then remove left outer casing
•
Turn the spring latches to lift then open air filter cover.
•
Remove the pleated paper filter
•
Blow the dust away with a compressed air
•
Reinsert the pleated paper filter into the air filter case.
•
Do not run the generator without reinstalling the foam element or excessive piston and
CAUTION!
cylinder wear may result, or excessive engine wear may result.
Inspect muffler for cracks, corrosion, or other damage.
•
Remove screws, then remove the muffler cover as shown.
•
Remove the cover, then remove muffler cap, muffler screen, and spark
•
arrester.
Check the muffler screen and spark arrester for carbon deposits.
•
Remove carbon deposits with a wire brush.
Check the muffler screen and spark arrester for damage. If damaged
•
replace with PULSAR replacement parts specifically designed for this
unit.
Install the spark arrester.
•
Align the spark arrester insert with the hole in the muffler pipe.
•
Install the muffler screen and rear grille.
•
Install the outer casing and tighten the screws.
•
WARNING!
•
• Allow hot components to cool before touching.
MAINTENANCE
Avoid contacting hot areas of this generator.
2
21
1
3
Order of removal
5