Publicidad
Idiomas disponibles
Idiomas disponibles
4. Install the Lavatory
Install the faucet to the lavatory following the faucet
manufacturer's instructions.
Properly seat the lavatory on top of the vanity. The back of the
lavatory must be flush against the finished wall.
Push down on each corner of the lavatory to make sure it does
not rock from side to side on the vanity.
NOTE: If adjustment is needed, remove the lavatory and set it aside.
Use a screwdriver to turn the levelers on the vanity. Seat the
lavatory on the vanity. Repeat this procedure, if necessary.
Remove the lavatory from the vanity and set it aside.
CAUTION: Risk of product damage. Siliconized acrylic caulk must
be used to secure the lavatory to the vanity. Do not use 100%
silicone sealant, which will damage the finish of the vanity.
Apply a 1/8" (3 mm) thick bead of water-based caulk around the
top edge of the vanity.
Carefully position the lavatory on top of the vanity.
Apply a small bead of water-based caulk to the top edge where
the lavatory contacts the wall. Allow the caulk to dry before
proceeding. Refer to the manufacturer's instructions for
recommended drying time.
Connect the drain and supplies.
Kohler Co.
Apply sealant.
7
Leveler
1061218-2-A
Publicidad
