Technical Specifications - 3M 26878 Manual De Usuario

• To reduce the risks associated with chemical exposure:
- Always wear appropriate personal protective equipment for eye, skin and respiratory protection
per the applicable SDS(s) and material container labels at all times when spraying�
• To reduce the risks associated with hazardous noise:
- Always wear hearing protectors when you are exposed to noise� Consult your work environment
and local regulations regarding use personal protective hearing protection�
• To reduce the risks associated with tripping, falling and tipping:
- Route air and liquid hoses and any extension cords away from traffic areas, sharp edges, moving
parts and hot surfaces� Do not pull on air hoses to move the compressor�
• To reduce the risks associated with impact:
- Always inspect to ensure that the atomizing head is properly attached and secure�
• To reduce the risks associated with sharp points:
- Do not touch the sharp end of the fluid needle when exposed and handle fluid needles carefully
during replacement�
• To reduce the risks associated with muscles strain:
- Avoid using spray equipment continuously without taking occasional breaks�
- Dispose of device components in accordance with local laws and regulations�
- Ensure equipment is cleaned prior to storage�
- Ensure equipment is stored indoors at room temperature�
- Do not put in gun washer� Do not leave immersed in cleaning solvents� See manual for
appropriate cleaning process�
- Solvent left in the spray gun air passages could result in a poor quality coating finish� Do not use
any cleaning method which may allow solvent into the spray gun air passages� Do not expose air
flow control valve and gauges to solvent as damage may occur�
The code of P affixed to this product indicates that the product in question has the designation
of machinery, designation of series or type, and manufacturer's address identified in this
documentation, in compliance with the Machinery Directive 2006/42/EC.

Technical Specifications:

Declared Dual-Number Noise Emission Values according to EN ISO 4871
A-WEIGHTED EMISSION SOUND PRESSURE LEVEL AT THE WORKSTATION:
Measured value: LpA =
81,8
Uncertainty: KpA = 2,5 dB
A-WEIGHTED SOUND POWER LEVEL:
Measured value: LWA =
Uncertainty: KWA = 2,5 dB
Values determined according to noise test code EN 14462 using the basic standards
EN ISO 11201 - grade 2, and EN ISO 3741
Usage Rated -
NOTE: The sum of a measured noise emission value and its associated uncertainty represents an upper
bound of the range of values which can occur in the measurements�
IMPORTANT NOTE: The noise values stated are from laboratory testing in conformity with stated
codes and standards and are not sufficient risk evaluation for all exposure scenarios� Values measured
in a particular work place may be higher than the declared values� The actual exposure values and
amount of risk or harm experienced to an individual is unique to each situation and depends upon the
surrounding environment, the way in which the individual works, the particular material being worked,
work station design, as well as upon the exposure time and the physical condition of the user� 3M
cannot be held responsible for the consequences of using declared values instead of actual exposure
values for any individual risk assessment�
CAUTION
NOTICE
dB(A) (ref 20μPa)
dB(A) (ref 1 pW)
89,8
7