Installing The Anchor; Installing The Virtual Anchor On The Motorcycle; Operating Instructions; Hybrid Wiring - Preparation - GIMOTO V-RACE RR HYBRID Manual Del Usuario

EN
3

- INSTALLING THE ANCHOR

Virtual cable may not work properly if instructions are not followed carefully.
If you have any questions, contact the Manufacturer or authorized Dealer.

3.1 INSTALLING THE VIRTUAL ANCHOR ON THE MOTORCYCLE

(fig_3.1)
Kit contents (fig_3.2):
1 Electronic anchor
2 Adhesive Velcro fastener
Place and fix the electronic anchor using the adhesive Velcro fastener in a place of your choice
on the motorcycle (e.g. at the front or aside), but make sure to locate it behind the seat (fig_3.3).
4

- OPERATING INSTRUCTIONS

4.1 HYBRID Wiring - Preparation - (internal use with the suit
Mod MR101 - Racer Air Series)
The "HYBRID" wiring provides the system connection via mechanical cable (see attached
booklet) and virtual cable.
■ Open the zipper (1) and lift the back protector covering the inner vest (fig_4.1).
■ Insert the electronic connector (1) through the opening (2) and pull it out of the other side of
back protector (Fig. 4.2). Connect the carabiner of the mechanical cable (3 - see attached
manual). Now you can lower the back protector and close the zipper.
■ Connect the pyrotechnic cable connector on the vest with the connector inside the suit. (fig_4.3).
■ Connect the mechanical cable. (3 fig_4.2 - see attached manual) and complete the adapter
setup.
4.2 ELECTRONIC Wiring - Preparation - (internal use with
the suit Mod MR101 - Racer Air Series)
The "ELECTRONIC" wiring provides the system connection via virtual cable only.
■ Open the zipper (1) and lift the back protector covering the inner vest (fig_4.4).
■ If the mechanical connection was previously used, withdraw the cable (1) and secure it
with a Velcro strap (2). It is recommended to fix also the cable connecting the pyrotechnic
actuator to the antenna (4 fig_4.5) with a Velcro strap (3).
■ During the ELECTRONIC-ONLY configuration, unhook and store the carabiner. (fig_4.6)
■ Manually make sure that the cartridge is well inserted into its housing so that you can close
the back protector properly. (fig_4.7).
■ Connect the pyrotechnic cable connector on the vest with the connector inside the suit.
Then insert the vest inside the suit (fig_4.8).
■ Complete the adapter setup (see attached manual).
24
Virtual cable