jbc CT-SA Manual Del Usuario página 4

Fixing the CT-SA
screw
washer
Spacers
Workbench
self-locking nut
The screws, washers and the self-locking nuts are not included
To fix the CT-SA in place, put the spacers (Ref. 0014899) between the stand and the workbench.
This means you protect the stand's rubber feet from wear and tear.
Use screws (we recommend M4) and assemble washers and self-locking nuts.
Once fixed in place, check that the stand is stable and leveled.
Spatulas
Use the spatula to eliminate the dross (Oxide
and other contaminants that form on the
surface of molten solder)
4 4 4