How To Operate Your Ceiling Fan; Important - Fanimation AIREHUG LP7668LBL Manual De Instrucciones

How to Assemble Your Light Kit or Cap (Continued)
7. Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually
snaps onto the light kit.
(Figure 7)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting process.
(If not used for long periods of time, remove battery to
prevent damage to transmitter). Store the remote away
from excessive heat or humidly. (Figure 3)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
Do not over-tighten.

How to Operate Your Ceiling Fan

until it
Light Kit
11
Figure 7
For illustrative purposes only-not
intended to cover all types of controls
Figure 1
Figure 2
12V 23A
Battery (1 pcs)
Figure 3
Glass
Main Fuse Box