Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble Rotating Child's Tray
Align the rotating child's tray end with matching component, and then push down to assemble.
The completely assembled stroller is shown as
13
Stroller Operation
Adjust Recline
Recline Backrest
There are 4 angles for the backrest.
To recline the backrest, squeeze the recline handle on the back of the seat
To raise the backrest, push up.
!
Make sure the recline is set properly for use.
Use Rotating Child's Tray
The rotating child's tray can be pulled up on both left and right sides.
To open the rotating child's tray, press rotating child's tray release button
- 2
child's tray.
16
Tip
Rotating child's tray can be open for easily placing and removing child.
Use Buckle
Release Buckle
Press the center button to release the buckle.
17
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A click sound means the buckle is locked completely.
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
- 1
19
Shoulder harness anchor A
- 2
19
Shoulder harness anchor B
- 3
19
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
Use either shoulder harness anchor in the slots that are closest to child's shoulder height.
Use slide adjuster to change the harness length.
- 2
Press the button
21
, while pulling the waist harness to proper length
11
12
.
14
, pull down on the backrest.
- 1
16
, and then pull up the rotating
- 1
18
, and click into the center buckle.
18
- 3
18
20
- 1
21
- 3
21
.
Adjust Calf Support
The calf support has 2 positions.
To adjust the calf support, press the adjustment buttons underneath the calf support
support downward or upward.
Use Front Swivel Lock
Pull up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.
Use Brake
To lock wheels, step backwards on either of the brake levers as
15
release wheel.
Tip
The brake must be engaged when placing and removing children.
Tip
Always apply brake when stroller is in stopped position.
Use Hood
To open the hood, pull hood towards front.
To fold the hood, pull up the stretchers on both sides and push hood toward back.
Fold Stroller
Push secondary lock
the stroller by tucking storage latch onto the storage mount
completely.
Use Carry Strap
- 2
Securely grab the carry strap for easy transportation.
Care and Maintenance
1. Removable seat pad may be washed in cold water and drip-dried. No bleach.
2. To clean stroller frame, use only household soap and warm water. No bleach or detergent.
3. From time to time check your stroller for loose screws, worn parts, torn material or stitching. Replace
or repair the parts as needed.
4. Excessive exposure to sun or heat could cause fading or warping of parts.
5. If stroller becomes wet, open hood and allow to dry thoroughly before storing.
6. If wheels squeak, use a light oil (e.g., WD-40, antirust oil, or sewing machine oil). It is important to get
the oil into the axle and wheel assembly.
7. When using your stroller at the beach, completely clean your stroller after use to remove sand and salt
from mechanisms and wheel assemblies.
- 2
22
25
- 1
27
and squeeze one-hand fold handle
28
29
1
- 1
22
and rotate the calf
23
, Step forwards on the brake lever to
24
26
- 2
27
. Push the stroller forward to fold. Lock
- 1
28
. The stroller is folded and locked
12
Publicidad
