Operation; Starting The Engine - Troy-Bilt Squall 2100 Manual Del Operador

Operation

Starting the Engine

WARNING!
moving parts. Do not use a pressurized starting
fluid. Vapors are flammable.
NOTE:
Allow the engine to warm up for a few minutes after
starting. The engine will not develop full power until it reaches
operating temperatures.
Electric Starter
WARNING!
grounded three-wire power cord and plug, and is
designed to operate on 120 volt AC household
current. It must be used with a properly grounded
three-prong receptacle at all times to avoid the
possibility of electric shock. Follow all instructions
carefully prior to operating the electric starter. DO
NOT use electric starter in rain.
1. Determine that your home's wiring is a three-wire grounded
system. Ask a licensed electrician if you are unsure. If you
have a grounded three-prong receptacle, proceed as
follows. If you do not have the proper house wiring, DO
NOT use the electric starter under any conditions.
2. Insert the ignition key fully into the slot, Fig. 5-1. Make
sure it snaps into place. DO NOT turn the ignition key. The
engine cannot start unless the key is inserted into the
ignition switch.
12
Always keep hands and feet clear of
The electric starter is equipped with a
Figure 5-1
3. Plug the extension cord into the electric outlet located on
the plastic shroud. Plug the other end of extension cord
into a three-prong 120-volt, grounded, AC outlet in a well-
ventilated area. See Fig. 5-2.
Figure 5-2
4. Move the throttle control to the FAST (rabbit) position.
5. Move the choke to the ON position (cold engine start). If the
engine is warm, place the choke in the OFF position.
6. Push the primer three to five (3-5) times, making sure to
cover the vent hole when pushing. If the engine is warm,
push the primer only once. Always cover the vent hole
when pushing. Cool weather may require priming to be
repeated.
7. Push the starter button to start the engine.
engine starts, immediately release the starter button.
The electric starter is equipped with thermal overload
protection; the system will temporarily shut-down to allow
starter to cool if electric starter becomes overloaded.
8. As the engine warms, slowly rotate the choke control to
the OFF position. If the engine falters, restart the engine
and run with the choke at half-choke position for a short
period of time, and then slowly rotate the choke into the
OFF position.
9. After the engine is running, disconnect the power cord
from the electric starter. When disconnecting, always
unplug the end at the wall outlet before unplugging the
opposite end from the engine.
5
Once the