Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING THE
ROLLER ASSEMBLIES
Insert the roller assemblies (L) into
1.
the mounting slots (Fig. 13).
2.
Adjust the height of the roller
assemblies (L) as needed.
3.
Lock the roller assembly in
position by tightening the
locking knob (K) (Fig. 14).
4.
The roller assemblies can also
use as a stationary stop guide,
and work as positive stops for
repetitive cuts.
ROLLER OPERATION
When working on a long workpiece,
the extension bars and rollers
are needed.
The roller can be used as a stop
guide or a single directional roller.
•
When using the roller as stop
guide, place the workpiece
against the plate; the roller
assembly works as an stop
guide to cut the workpieces to
the length required (Fig. 15).
•
When using the roller assembly
as a single roller, place the
workpiece on the roller for
convenient operation (Fig. 16).
Page 12
Fig. 13
Stop guide
Mounting
slot
Fig. 14
Fig. 15
Stop guide
Steel plate
Fig. 16
L
Kerf
16491 Manual_Revised_1 -0
K
Publicidad
