Installation - Omnitronic CDP-744 Manual Del Usuario

A sequence can be memorized after you memorized the Loop In-point. Please select the end-point (Loop
Out-point) with the Jog-dial (Pause-mode) or directly during playback (OUT/EXIT-LED illuminated). By
pushing the joystick upwards, you can memorize the current position (OUT/EXIT-LED flashes).
The memorized sequence is repeated (OUT/EXIT-LED flashes) until you push the joystick upwards once
more.
18. RELOOP-BUTTON
Via the RELOOP-button, you can call up a memorized sequence once more. As soon as you leave the Loop-
mode (LOOP IN and OUT/EXIT-LEDs illuminated), the RELOOP-button starts flashing. As soon as you press
the RELOOP-button, the memorized sequence will be repeated.
Rear panel:
19. CONNECTOR PORTS
Connect the player-unit here.

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect it
to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the available voltage is not higher than stated on the rear panel.
Connect your CD-player with the mains.
Switch the device on. After switching on the amplifier, wait 8 to 10 seconds until you turn the volume-controls
in order to avoid speaker-damage.
Under all circumstances avoid amplifier clipping. Distorted signals are the major cause of speaker-damage.
23