Speed Adjustment - Campbell Hausfeld Cl15 Serie Instrucciones De Operación

Operating Instructions
Operation (Continued)
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutomAtic lubricAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127001AV or equivalent ISO
grade 32 oil.
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (Refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions, if applicable, for 20 to 30
seconds. Oil will discharge from the
exhaust port when air pressure is
applied.
4
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
beAring lubricAtion
TOOLS wITH GREASE FITTINGS
(MODEL CL1512)
Inject approximately 4cc of general
purpose bearing grease every 8 hours of
use or as required.

speed adJustMent

The impact wrench should never be used
to set torque. Use a torque wrench to set
the torque. All models are equipped with
regulators for speed adjustment (Refer to
parts manual for tool features).
To remove lugs or bolts, set the regulator
to the maximum setting. when installing,
always use a torque wrench to attain the
proper torque of the lugs or bolts.
overtighten. Bolts may fail or cause a
hazardous condition. Be sure to set the
regulator to the minimum setting then
use a torque wrench to set torque.
When reassembling
be careful not to