Table Of Parameters; Reset To Factory Settings; Maintenance; Removing The Casing - Beretta Idrabagno Lx 11Serie Manual Del Instalador Y Usuario

ENGLISH

4.8.1 Table of parameters

Nr.
PARAMETER DESCRIPTION
PAR
2 Selecting water heater output/capacity
4 Selecting methane/LPG
5
6 Domestic hot water start wait time
11 maximum setpoint of domestic hot water circuit
20 Induced draught protection function
40 Type of domestic hot water thermostat operation
41 Displaying domestic hot water input temperature
42
rt Exiting the menu
rs Resetting factory settings

4.8.2 Reset to factory settings

MENU.
If no action is taken, once 2 minutes have passed the appliance exits the menu and returns to the normal operation screen.
b
If you are replacing the electronic board it is necessary to set the parameters 2
heater used.

5 MAINTENANCE

To ensure correct operation over time, the appliance should be checked
IMPORTANT : before performing any cleaning or maintenance work, or
before opening or removing the boiler panels, turn the appliance off by
shutting off the gas tap.
Check
obstructed. Use a wet soapy cloth to clean the external panels.
Do not use abrasive solvents, powders or sponges.
Do not
substances such as : petrol, alcohol or heavy oil.
electrode position and distance.
Check
See Fig. 39
b

Models for outdoor installation

discharge open the cover by unscrewing the screws A .
See Fig. 40

6 REMOVING THE CASING

6.1 Models for indoor installation

To remove the casing:
- disconnect the appliance from the electric power supply using the om-
nipolar switch
- remove the two screws A
- pull the casing B forwards
- lift the casing B upwards releasing it from the hooks at the top
See Fig. 41
24
7
: If you need to inspect or clean the
UNIT OF
MEASURE- MIN MAX
MENT
l/min
s 0,5 10
°C 36 65
0 1
°C
Models 11-13
outwards
See Fig. 42
Models 17
To open the instrument panel:
- remove the screws C
- slide the instrument panel out and rotate it to the stop position
See Fig. 43
6.2 Models for outdoor installation
To remove the casing:
- disconnect the appliance from the electric power supply using the om-
nipolar switch
- remove the three screws A of the top discharge
- pull the top discharge upwards
See Fig. 44
- remove the two screws B
- push the casing C forwards
- move the casing C upwards, freeing it from the top hooks
See Fig. 45
VALUES FACTORY SETTING
11
13
17
NOT USED
4
11
13
17
0
0.5s
65
1
0
and turn it
C