Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – CFA
Step 1
Remove fixtures from carton.
●
●
Remove Lens (B) by gently squeezing & pulling a few inches at a time from one end to the other.
●
●
Remove (2) Hex Nuts (I) in order to remove Power Tray© from Fixture Housing (A). Keep Hex Nuts (I) for later use.
●
●
Detach Power Connectors as shown.
●
●
OPTIONAL:
Plug-in
Connectors for
Row Mounting
(0540-pi01-4-2pp)
Step 2
Follow Step 2 for stand alone fixtures or to mount first
●
●
fixture at one end of row for series mounting.Align
Fixture Housing (A) with 2" T-grid as shown and fasten
with mounting screws through pre-drilled holes.
Holes may be enlarged for use with larger mounting
●
●
screws.
Alternate mounting holes may be drilled on back of
●
●
housing. See Drill Guide Diagram in Step 3.
T-grid Ceiling
Single Fixture
2
Mounting Screws (by others)
Housing (A)
Installation Instructions – CFA
IS-083
ADC140279
Lens (B)
Power
Tray©
Hex Nut (I)
Power
Connectors
Housings (A)
Step 3
Drill Guide Diagram
Optional
A drill guide groove runs along back of the fixture for easy
●
●
customization.
Alternate mounting or access holes can be drilled within
●
●
4" from the endcap or in locations not interfering with
internal components, (ex. ballast, etc.).
Ceiling
Internal Guide
Groove
www.cooperlighting.com
OPTIONAL:
Plug-in
Connectors for
Row Mounting
(0540-pi01-4-2pp)
Clean Room
T-Grid
Housing
Channel
Publicidad
