Publicidad
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 16)
Print Port Header
AFD#
ERROR#
PINIT#
(25-pin LPT1)
(see p.2 No. 21)
1
SPD1
SPD0
STB#
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 24)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 18)
ASRock H61M-GE Motherboard
This header can be used to
connect the remote
1
GND
IRTX
controller receiver.
IRRX
ATX+5VSB
This is an interface for print
port cable that allows
GND
SLIN#
convenient connection of printer
devices.
SPD7
SPD6
ACK#
SPD5
BUSY
SPD4
PE
SPD3
SLCT
SPD2
This is an interface for front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
®
TM
7 / 7 64-bit / Vista
/ Vista
This header accommodates
several system front panel
functions.
TM
64-bit OS:
23
Publicidad
