Troubleshooting
RFID function can be used only after the control panel is
connected to the power adapter
No response when
swiping RFID tag
Check if the RFID tag is paired to the control panel. If not,
please pair it again
Swiping RFID tags
Check if RFID SMS notification number and RFID tags
without sending
name were stored
SMS notification
The detector, remote
Press the tamper switch on the bottom of control panel for
control and other
three times within 5 seconds, and all the connection between
accessories do not
the control panel and accessories will be cleared. Pay
response any more
attention not to trigger the tamper switch frequently when
after the control
installing the control panel
panel is moved
Whether the SIM card has enabled Caller ID Display function
Get replied SMS
"Phone number is
unauthorized. "
Whether the cell phone number is set as alarm number
When the GSM network indicator blinks once per second
GSM network
the network is being searched. When the indicator blinks
indicator blinks
once every two seconds a network has been found.
When the PIR motion detector is triggered 2 times in 3
minutes it automatically goes into power saving mode.
When no movement is detected in the next 3
Motion detector
minutes it will set itself in the normal mode. During the 3
doesn't seem to
minutes the detector won't be active and will not send a
work properly
signal to the control panel. As long as motion is detected
within the 3 minutes the power saving mode will be
extended.
55
X500-UM-EN-IT-ES-PT-V1.0.indd 62-63
Caution and Warnings
Due to laws and regulations determined by the Euopean Parliament, some (wireless)
devices may be subject to restrictions on its use in certain European countries. In some
EU Member States, the use of equipment are prohibited. Contact your (local)
government for more information on these restrictions.
Always follow the instructions in the manual, especially when it concerns devices which
need to be assembled.
Warning: in most cases it is an electronic device. Incorrect or improper uses of the
device may result in (serious) injuries.
Repairing the unit must be done by smanos qualified personnel. The warranty expires
immediately if the unit is repaired and/or when the product is misused.
Note:
smanos manuals are made with the utmost care. Due to new
technological developments, it may happen that a printed manual does not
contain the latest information.
Note:
If you experience problems with the printed instructions, always visit our
website
www.smanos.com
where the most recent manual is available for
downloading.
EN
56
2016/12/9 9:27:56