Tabla de contenido
Publicidad
Zone mode of sensors
Each sensor can be placed in a zone mode. Four different zone mode can be selected.
The home mode zone, normal zone, 24 hour zone or single delay zone. Please refer
to page 23 for setting the zone mode.
IMPORTANT:
Determine before setting the alarm system which zone a sensor
should be placed.
Normal zone:
The supplied door/window contact is by default set in the normal
zone. In the normal zone setting, a sensor is always activated when the alarm
system is armed.
Home mode zone:
The supplied PIR motion detector is by default which set in
the home zone. When the alarm system is in home mode, the sensors set in
home zone will send a signal to the alarm system when triggered but does not
respond to the signal. Sensors in the normal zone will send a signal when
triggered and the alarm system will respond. With the home zone it is possible
to partially arm the house with the advantage of being able to walk around in it.
Single delay zone:
One or more detectors can be set in single delay zone that
will alarm at the specified time after being triggered. The state is usually used
for door/window contact on entrance. For example, if the user does not want to
carr y the remote control, he/she can set the door/window contact in single
delay zone and set the time to 30 seconds. When the user comes home, the
control panel will alarm after 30 seconds, so it leaves certain time for the user to
disarm the system.
24 hourzone:
It is recommended to set smoke detector, gas leakage detector,
vibration detector, glass break detector, water flood detector and IR beams to
24 hour zone. When set to this zone the sensor is always active and will always
send a signal without delay to the control panel when triggered, regardless
whether the system is armed or disarmed.
5
X500-UM-EN-IT-ES-PT-V1.0.indd 12-13
Changing sensor name
The supplied motion detector and door/window contact are by default paired with the
alarm system. Every sensor is called a zone and every sensor will get it's own zone
number assigned. The door/window contact is by default assigned to zone 1. The
motion detector is by default assigned to zone 2. Each sensor that will be assigned
afterwards will become zone 3, zone 4... in the sequence of pairing order. Names can
be set up to 50 zones.
Test mode alarm system
The alarm system can be put in a testing mode. This will cause the alarm beep
three times when it getting a signal from a sensor which is triggered, instead of
ringing the siren.
The test mode can be started by sending "100" to SIM card which is inserted in
the control panel. After 10 minutes the system will automatically stop the test
mode. It is also possible to stop the test mode by pressing the
the control panel.
Record alarm message
When the alarm is activated, the control panel will call the pre-stored
emergency numbers and play a message. This message can be changed by
pressing the button, press again the
[0]
button. From that point you have 10 seconds to leave a message.
EN
[SOS]
button on
button and finally press the
6
2016/12/9 9:27:47
Publicidad
Capítulos
Tabla de contenido
