Control Panel Operation; Arming The System; Partially Arming The System; Disarming The System With The Control Panel - Smanos X500 Manual Del Usuario

Sending " ? ? "
Control panel replies:
'5' Store alarm phone No.
'6' Store alarm SMS No.
'7' Store SMS No. for RFID tags
'8' Store speed dial phone No.
'???' System setups
Sending " ? ? ? "
Control panel replies:
'901-950' Zone name
'101-120' RFID tags SMS notice
'11' Entry and exit delay time
'121' Siren volume
'122' Siren ringing time
'13' Disarm password
'14' Single zone delay time
'15' Duress code
'16' Timing
9
X500-UM-EN-IT-ES-PT-V1.0.indd 16-17
??
???

Control Panel Operation

Arming the system

Press . All the sensors will be activated.

Partially arming the system

Press . Sensors which are set in the home mode zone will not active when home arm
is activated. All other sensors in other zones will remain active.

Disarming the system with the control panel

Disarming the system with the control panel can be done by entering the 4-digit
password (default 1234) and press the button. You will hear one beep and the
system will be disarmed. If you hear three beeps, the password is entered incorrectly.

Disarming the system by RFID tag

Hold the RFID tag close to the RFID reader. The system will beep as a confirmation it is
disarmed.
IMPORTANT: The control panel must be
connected to AC adapter when using a RFID
tag to disarm the system.
IMPORTANT: RFID tags can only be used to disarm the system.
EN
10
2016/12/9 9:27:50