Assembly & Set-Up - Troy-Bilt FLEX 23AABA6X711 Manual Del Usuario

Assembly & Set-Up
Assembly
Installing the Discharge Chute
A discharge chute, wire spring, and chute band, have been
included with this attachment. Please assemble them now
by installing the discharge chute onto the snow thrower by
following these steps:
1. Install the wire spring into the discharge opening
of the snow thrower by inserting both ends into the
slots provided. See Figure 3-1 for proper location and
orientation of the spring. The inset of Figure 3-1 shows the
spring properly installed with the ends fitted into the slots
provided.
Figure 3-1
2. Install the discharge chute, packed loose in the carton,
onto the snow thrower attachment, as shown in Figure 3-3.
Note: Position the discharge chute at an angle to the right
for ease of installation.
3. Clip the discharge chute handle onto the discharge chute,
as shown in Figure 3-2.
Figure 3-2
Note: Place a dab of white lithium grease (included with
this attachment) onto the chute ring, chute spring, and
chute adapter ring prior to assembly.
Figure 3-3
4. Install the chute band as shown in Figure 3-4. With the
discharge chute positioned to the right as shown, install
the chute band by lining up the notches in the front with
the band, and making certain to fit the discharge chute
inside the channel of the chute band, as detailed in the
inset of Figure 3-4.
Figure 3-4
3
7