Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8
SAFETY INSTRUCTIONS
• Do not use the appliance for other than its intended use. For domestic indoor use
only.
• Place the appliance on a fl at, stable, heat-resistant surface. Operating the product
in any other position could cause a hazard.
• Never insert anything into the grille when the fan is switched on. Adults should pay
special attention when using this fan close to children.
• Never use this fan in hot or humid locations like a bathroom.
• Never leave this fan close to curtains, drapes, plants, etc.
• Always unplug or disconnect the appliance from the mains power supply when not
in use or when moving or cleaning it. Do not pull the cord to unplug the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualifi ed persons in order to avoid a hazard.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
CAUTION
Risk of injury! Never use without the guards in place. After assembly, do
not remove the guards during use or cleaning.
ASSEMBLY
1
Fix the leg tripod (1) into base (2).
2
Loose the screw (4) from the inner tube and take the inner tube out from the main tube
by rotating the height adjusted locker (3) anti-clockwise.
3
Rotate the height adjusted locker (3) clockwise after you adjust the fan body to your
desired height.
4
Fasten the fan body (5) to the inner tube by fi xing the screw (4).
5
Remove the rare grille nut (9) from the motor shaft (7).
6
Fasten the rare grille to the body of the motor house with the handle positioning on
top.
7
Fix the rare grille locker (9) to the motor shaft (7).
8
Place the fan blade (10) on the shaft (7) of the motor so that the notches correspond
to the grooves on the shaft. Secure with nut (1 1).
9
Place the front grille (13) on the rare grille and secure with the fan ring (12) with safety
screw positioning at the bottom.
Publicidad
