Southland SCS2052.1 Manual Del Operador página 19

Operation
• Save these instructions
E
Chipping
Branches up to 2.5" (63.5 mm) in diameter can be fed into the chipper chute.
NOTICE
Never feed branches with a diameter greater than 2.5" (63.5 mm) into
the chipper chute. Doing so can result in serious damage to your machine's chipper
blades, flails or impeller.
Observe the following guidelines when chipping branches:
• Never feed more than one branch into the chipper chute at a time.
• Never feed anything other than branches (or wood) into the chipper chute.
• Wood objects placed into the chipper chute will feed rapidly. Loosely grip branch
and release once feeding starts.
NOTE: For best performance, always operate the machine with sharp chipper blades.
If a noticeable loss in performance is encountered while chipping branches, the chipper
blades should be replaced.
F
Emptying the Debris Bag (Fig. 5)
Questions? Call Toll Free at 1-800-737-2112
1.
2.
17
11
3.
4.
Figure 5
ENG - 19
Stop engine. Refer to Stop Engine
paragraph under Start-up.
Depress the cord lock (17) and slide it up
the drawstring to loosen drawstring on
chute deflector.
Remove and empty the debris bag (11).
Reattach the bag to the chute deflector
opening. Refer to the Debris Bag paragraph
under Assembly.
Copyright © 2015 MAT Engine Technologies, LLC