ASROCK Z590M Pro4 Manual Del Usuario página 26

Front Panel Type C USB
3.2 Gen1 Header
(20-pin USB3_TC_1)
(see p.1, No. 11)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 30)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
22
There is one Front
Panel Type C USB 3.2
Gen1 Header on this
motherboard. This header
is used for connecting a
USB 3.2 Gen1 module for
USB Type-C Cable
additional USB 3.2 Gen1
ports.
This header is for
GND
PRESENCE#
MIC_RET connecting audio devices
OUT_RET
to the front audio panel.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L