Extended Operation Mode - Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador

11

Extended operation mode

N.B.: if you are only using the simplified mode the
value of the invisible parameters - for a control
unit leaving the factory, or after a reset of the
standard parameters - this is the one shown next to
the parameter, and is considered to be of greater
usefulness in installations.
parameter number
selectable values
A2 00
Automatic reclosing after the rest time
00
OFF (doesn't automatically relock)
01 15
NUMBER of reclosure attempts (interrupted by photocell) before finally staying open
-
99
try to close without limitation to the number of attempts
NOTE: parameter
To enable automatic reclosing you must set this parameter to a different number from
setting the value
01 15
and , that is the maximum number of attempts at reclosing carried out. For example, by
setting the value
if a person crosses the ray of the reversal photocells when reclosing, the leaves would re-open but would no
longer close (only performs one reclosing attempt).
Automatic locking is only performed if the leaf reaches the fully open position.
NOTE: the value of parameter
has a maximum value equal to that of parameter
A3 00
Reclosing after blackout
00
OFF (does not reclose when the power is restored)
01
ON (recloses when the power is restored)
NOTA: parameter
If this parameter is set to
lasting 5 s (even if not enabled on parameter
supply voltage during the reclosing because it guarantees that the gate is closed when the supply
voltage is restored.
28
A2 00
00
01 15
-
1-
in simplified mode
99
will it always reclose after the rest time. However, if you set a number between
01
,
49
is subordinate to that selected for parameter
3-
in simplified mode.
01
lthe control unit, when on, performs the reclosing after a pre-flashing
WARNING! Depending on the selected mode,
some parameters may not be displayed, as they do
not relate to the installation.
The table for the extended mode parameters is
below. The standard production value is next to the
parameter number.
standard
production value
Parameter description
function associated with the value 00
function associated with values from 01 to 15
a2
.
A5
). This feature is useful when there is no longer the
00
; only by
a2 49
; parameter