HIKVISION DS-2DF6A832X-DE3 Guia De Inicio Rapido página 13

FCC compliance: This equipment has been tested and
found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
EU Conformity Statement
This product and - if applicable - the
supplied accessories too are marked with
"CE" and comply therefore with the
applicable harmonized European standards
listed under the Low Voltage Directive 2014/35/EU, the
EMC Directive 2014/30/EU, the RoHS Directive
2011/65/EU, and RE Directive 2014/53/EU.
2012/19/EU (WEEE directive): Products
marked with this symbol cannot be
disposed of as unsorted municipal waste in
the European Union. For proper recycling,
return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more
information, please see: www.recyclethis.info.
2006/66/EC (battery directive): This product
contains a battery that cannot be disposed
of as unsorted municipal waste in the
European Union. See the product
documentation for specific battery
information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling, return
the battery to your supplier or to a designated
collection point. For more information, please see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A)
standards requirements.
이 기기는 업무용 환경에서 사용할 목적으로
적합성평가를 받은 기기로서 가정용 환경에서
사용하는 경우 전파간섭의 우려가 있습니다.
Safety Instructions
Warnings
Laws and Regulations
The device should be used in compliance with local
laws, electrical safety regulations, and fire prevention
regulations.
Electrical Safety
CAUTION: To reduce the risk of fire, replace only with
the same type and rating of fuse.
This equipment shall be installed incorporated with
UPS to avoid the risk of restart.
Battery
This equipment is not suitable for use in locations
where children are likely to be present.
CAUTION: Risk of explosion if the battery is replaced by
an incorrect type.
Improper replacement of the battery with an incorrect
type may defeat a safeguard (for example, in the case
of some lithium battery types).
Do not dispose of the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may result
in an explosion.
Do not leave the battery in an extremely high
temperature surrounding environment, which may
result in an explosion or the leakage of flammable
liquid or gas.
Do not subject the battery to extremely low air
pressure, which may result in an explosion or the
leakage of flammable liquid or gas.
Dispose of used batteries according to the instructions.
Cautions
Fire Prevention
No naked flame sources, such as lighted candles,
should be placed on the equipment.
The serial port of the equipment is used for debugging
only.
Hot Surface
CAUTION: Hot parts! Burned fingers when handling the
parts.
handling parts.
The device with this sticker is intended for installation
in a restricted access location. Access can only be
gained by service persons or by users who have been
instructed about the reasons for the restrictions
applied to the location and about any precautions that
shall be taken.
Installation
Install the equipment according to the instructions in
this manual.
To prevent injury, this equipment must be securely
attached to the ceiling/wall in accordance with the
installation instructions.
Be sure that there is enough space to install the device
and accessories.
Make sure that the wall is strong enough to withstand
at least 8 times the weight of the device and the
mount.
Make sure that the power has been disconnected
before you wire, install, or disassemble the device.
12
This sticker is to indicate that the
marked item can be hot and
should not be touched without
taking care. Wait one-half hour
after switching off before