noken SMART ECO Manual De Instrucciones página 17

Press the [On/Stand-by] button to power on the device or to activate the "Stand-by" mode; during the "Stand-
by" mode, all led are off.
NOTE: When the device enters the "Stand-by" mode, it beeps twice for 0,5 seconds. When the device is swit-
ched to "On" mode (i.e. it is switched on), it beeps once for 1sec.
"Continuous-heating" mode: it is possible to activate this function through the [ON/Stand-by] button, the hea-
ting element is activated and remains active (hence heating the towel radiator) until the function is deactivated
through the [ON/Stand-by] button. From this mode it is possible to activate the functions: "Boost", "Timer12" e
"Timer24".
Note: the maximal reachable temperature depends on the power of resistance (see technical specifications).
Note: For safety reasons the temperature will be regulated to a safe temperature to avoid excessive overhea-
ting, depending on the power of the resistance
"Boost" mode: Press the [Boost/Timer] button to activate this operative mode. This mode activates the heating
element to the maximum power for 2hrs.
To exit the "Boost" mode press the [Boost/timer] button.
"Boost" mode indication: "Boost/Timer" LED has red color and it blinks
"Timer24" mode: Press the [Boost/Timer] button for 3 seconds to activate this mode.
The control system activates the "Boost" mode for 2 hours, after that it returns into "Stand-by" mode and after
22 hours the "Boost" mode is started again for 2 hours. This sequence will repeat endlessly.
To exit the "Timer24" mode press the [Boost/Timer] button.
NOTE: During the first cycle the duration of the "Stand-by" mode is of 21 hours
"Timer24" indication during 2hrs "Boost": "Boost/Timer" LED blinking green
During 22hrs "Stand-by": "Boost/Timer" LED permanent green
"Timer12" mode: Press the [Boost/Timer] button for more than 5 seconds to activate it. The control system ac-
tivates the "Boost" mode for 2 hours, after that it returns into "Stand-by" mode and after 10 hours the "Boost"
mode is started again for 2 hours. This sequence will repeat endlessly. To exit the "Timer12" mode press the
[Boost/Timer] button.
NOTE: During the first cycle the duration of the "Stand-by" mode is of 9 hours
Timer12 mode (boost 2h): Boost/Timer led amber and blinking
"Stand-by" mode (10h): Boost/Timer lit and amber
Note: For safety reasons the temperature will be regulated to a safe temperature to avoid excessive overhea-
ting, depending on the power of the resistance.
ENG
17