Assembly; Leg Frame Assembly; Front Brake Cable Clip Installation; Handle Assembly - Graham Field LUMEX LX9000 Gaitster Manual Usuario

ASSEMBLY

LEG FRAME ASSEMBLY

1. Position the rollator frame assembly and leg
frame assemblies on their sides as shown at
near right.
2. Install the leg frame assemblies on inside of
rollator frame assembly as shown at right.
Info: for correct assembly, ensure wheel /
fork reflectors and rear wheel braking system
are on outside of frame.
3. Tighten both screws on outside of leg frame assemblies as shown above.
WARNING: Ensure the leg frame assemblies are securely installed before proceeding.

FRONT BRAKE CABLE CLIP INSTALLATION

Ensure there is no interference with the brake cable, and fasten the brake cable clip on outside of
leg frames, in front of frame junction, as shown above. This will help prevent the brake cable from
rubbing or being caught on anything.

HANDLE ASSEMBLY

WARNING: During assembly, do not place any
fingers or parts of your hand under the seat
support bars.
1. Position the rollator in upright position.
2. Push down on both sides of the seat to securely lock
the seat support bars into place as shown at right.
3. Install both handles in both frame tubes as shown at
right.
4. Move handles to desired height — note numbers on
handle shafts shown at right to match handle height.
Ensure both handles are adjusted to the same height.
5. Turn locking knobs clockwise to lock handles in place inside frame.
WARNING: Ensure locking knobs are securely tightened before proceeding.

CANE / CRUTCH HOLDER INSTALLATION

Push the cane / crutch holder into the frame connector
until it snaps into place, as shown at right.
WARNING: Ensure the cane / crutch holder is
securely installed before use.
LX_LX9000-INS-LAB-RevC21 6