Introduction; Intended Use; Features; Package Contents - Parkside PFS 710 C2 Traducción Del Manual De Instrucciones Original

SABRE SAW PFS 710 C2

Introduction

Congratulations on the purchase of your
new appliance. You have selected a high-
quality product. The operating instructions
are part of this product. They contain important in-
formation on safety, usage and disposal. Before
using the product, familiarise yourself with all oper-
ating and safety instructions. Use the product only
as described and for the specified areas of appli-
cation. Please also pass on these operating instruc-
GB
tions to any future owner.
MT

Intended use

The appliance with a fixed hinge is designed for
sawing, cutting to length and adapting wood,
plastics and construction materials. The sabre saw
is suitable for rough sawing work, straight and
curved cuts and cuts off surfaces flush. Follow the
information concerning saw blades and practical
advice on sawing. Any other uses of or modifica-
tion to the appliance is deemed to be improper
and carries the risk of serious personal injury. The
manufacturer accepts no responsibility for damage
attributable to misuse. The appliance is not meant
for commercial use.

Features

Stroke rate adjusting wheel
Locking switch
ON / OFF switch
Handle
Footplate
Saw blade
Quick-release chuck
Working light
Locking lever for footplate
Cover for carbon brushes
Release button
Saw blade for wood
Bimetal saw blade
32

Package contents

1 sabre saw PFS 710 C2
1 saw blade for wood HCS 152 mm
1 bimetal saw blade 152 mm
1 operating manual

Technical data

Rated voltage:
Nominal power input: 710 W
Nominal idle speed:
Stroke length:
Max.
cutting performance:
Sawblade mount:
Protection class:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration values (vector total of three directions)
determined in accordance with EN 60745:
Vibration emission value:
Cutting boards: a = 18.6 m/s
h,B
Uncertainty: K = 1.5 m/s
Cutting wooden beams: a
Uncertainty: K = 1.5 m/s
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance
with the standardised measuring procedure
specified in EN 60745 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
230 V ~ , 50 Hz
(Alternating current)
n 0 - 2800 min -1
0
20 mm
Wood 160 mm
Aluminium 18 mm
Metal 8 mm
1 / " (12.7 mm)
2
II /
L = 91 dB (A)
PA
K = 3 dB (A)
L = 102 dB (A)
WA
K = 3 dB (A)
2
2
= 17.6 m/s 2
h,WB
2
PFS 710 C2