Troubleshooting - Black+Decker BDEJS4C Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

rip / circle cutting (figure i, j)

Ripping and circle cutting without a pencil line are easily done with

the rip fence / circle guide (not included - available at extra cost).

Using the screw supplied with the accessory guide, position as

shown in figure i and thread the screw into the shoe to clamp

the fence securely.

When ripping, position as shown in figure i and slide the rip

fence under the screw from either side of the saw. Set the

cross bar at desired distance from blade and tighten screw. For

ripping, the cross bar should be down and against the straight

edge of the workpiece as shown.

When circle cutting, adjust rip fence so that distance from blade

to hole in fence arm is at the desired radius and tighten screws.

Place saw so that hole in fence arm is over center of circle to be

cut (drill hole for blade or cut inward from edge of material to get

blade into position). When saw is properly positioned, drive a

small nail through hole in fence arm. Using rip fence as a pivot

arm, begin cutting circle. For circle cutting, the cross bar should

be up, as shown in figure j.

Making a pocket cut (figure k),

it is not necessary to drill a pilot Hole:

• Mark the desired starting point.

• Tilt the tool forward and place the rounded front edge of the saw

shoe on the workpiece so the blade does not touch the surface.

• Switch the tool on and slowly feed the saw blade into the

workpiece at the desired starting point.

problem

• Unit will not start.

For assistance with your product, visit our website www.blackanddecker.com for the location

of the service center nearest you or call the BLACk+DeCkeR help line at 1-800 544-6986