Testing Your Fan - Litex Industries BNH44NI5C1S Guia De Instalacion

9. Light Kit Assembly (Optional). (cont.)
Align slots on glass shade with protrusions on the
inside of the light kit fitter. Twist glass shade to the
right.
Note: Pull down gently on the glass shade to make
sure that it is secured completely.
To allow for smoother operation of pull chains, thread
fan and light pull chains through their respective pull
chain guide on the light kit fitter.
If you wish to use fan WITHOUT the light kit,
remove hex nut and lock washer from threaded
rod at top of light kit fitter. Remove switch housing
cap. Locate small plastic cap in hardware pack and
insert cap firmly into hole in middle of switch
housing cap.
Align holes in switch housing cap with holes in
switch housing. (Note: The opening on the edge of
the switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Secure switch housing cap with 3 screws that were
just removed.

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull chain
labeled FAN. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to OFF setting. If
applicable, test light with the pull chain labeled LIGHT.
(diagram 1) If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch.
Set reverse switch to recirculate air depending on the
season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important: Reverse switch must be set either completely
UP or completely DOWN for fan to function. If the reverse
switch is set in the middle position (diagram 4), fan will
not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to ends of the pull
chains.
light kit
fitter
lock washer
switch housing
cap
connections
light kit fitter
light
pull chain
extension
diagram 1
diagram 2
page 7
glass
shade
hex nut
molex
cap
motor housing
switch
housing
reverse
fan pull
chain
extension
diagram 3 diagram 4
motor
housing
pull chain
guide
switch