Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12. Remote/Wall Control Operation.
handheld
remote control
2
III
IV
1
II
V
VI
I
4
Fan SPEED control buttons1:
Fan OFF button 2:
REVERSE function button 3:
LIGHTING button 4:
ON/OFF slider switch 5:
IMPORTANT
: The Automated Learning Process takes approximately 5 minutes to complete. Please
leave the fan "ON" for the duration of the 5-minute programming and do NOT use the
remote control or turn off the power during this time.
The fan will cycle through ALL SIX (6) speeds in forward and reverse and will then stop
automatically after the learning process is complete.
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation. Restore power
from circuit box and light switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall control, then set to the ON
position. Test light function and test fan speeds. Locate handheld remote control.
Test fan speeds with the different fan speed buttons (I - VI) on handheld remote
control. Test the light ON/OFF function by pressing the
control operates all of the functions of the fan, battery has been installed correctly.
If the wall and/or remote controls do (does) not operate all of the fan functions,
refer to "Troubleshooting" section to solve any issues before contacting Customer
Service.
Fan must be on LOW before setting the fan in reverse. Use
recirculate air depending on the season. A ceiling fan will allow you to raise your
thermostat setting in summer and lower your thermostat setting in winter
without feeling a difference in your comfort.
NOTE: If the wall control/handheld remote control interferes with other
appliances, activate a new code on the wall control/ handheld remote control by
turning the power off first. Go back to the instructions for the SET button in
Section 11 (page 10).
IMPORTANT: Handheld remote control and wall control must be synchronized
with fan in order to properly function.
IMPORTANT:
Handheld remote
control and wall
control must be
SYNCHRONIZED with
fan in order to
properly function.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
[Wall control only] Use to turn wall control on or off
button. If the remote
button to
page 11
wall control
2
III IV
1
II
V
I
VI
3
4
5
OFF
ON
III IV
II
V
I
VI
OFF
ON
IV
III
II
V
VI
I
Publicidad
Capítulos
Tabla de contenido
