On/Off Switch - Remington Precision PG-300 Manual De Uso Y Cuidado

G03-041 pg-300 web ib 9/1/05 9:45 AM Page 4
The MiniScreen shaver should be cleaned as follows:
Press the buttons at ends of screen head.
Remove head and shake out clippings.
Blow/brush off cutter.
Replace head–make sure that it snaps in place.
DO NOT RINSE or OIL MINISCREEN SHAVER.
The unit has been lubricated at the factory.
Troubleshooting
The groomer does not work when turned on:
Groomer must be charged for a full 14-16 hours.
Contact an authorized Remington Service Center
regarding battery replacement.
Groomer cutters do not move:
The cutting unit may be dirty and clogged. Clean and
lubricate the unit as directed in the Cleaning
& Maintenance section.
Groomer does not hold charge:
Fully discharge battery by running groomer until it stops;
then follow recharging instructions (see section on
Charging/Recharging). If time between recharging cycles
does not increase, battery may need replacing.
Contact an authorized Remington Service Center.
You need help,
service information or locations:
Call 800-736-4648 for the authorized Remington Service
Center closest to you in the U.S. or 888 277-6333 in Canada.
PG-300
This side for trimming
neckline & sideburns
Hair length attachment 1
Hair length attachment 2
MiniScreen
shaver attachment
This side for trimming
Nose, ear, eyebrow

On/Off switch

Groomer