Briggs & Stratton Snapper LT75 Serie Manual Del Operador página 10

Assembly
Assemble the Steering Wheel
1. Make sure the front wheels point forward as shown
in F F igure 3.
2. Slide the bellows (1, F F igure 3) over the console.
3. Slide the steering post (2) into the console.
7
3/8
4
5
1
6
4. Attach the steering wheel (3) to the steering post
(2) with screw (4) and washer (5). Tighten screw
but be careful not to over-tighten.
a. Push on the steering wheel. The steering post
will lock onto the pinion gear (6).
b. Pull on the steering wheel. Make sure that the
steering post is locked in place.
5. Install the plate (7) and cover (8) to the steering
wheel.
10
8
2
3
Figure 3
Assemble the Grass Bag
1. Slide the bottom tube (1) onto the bagger frame (2)
(see F F igure 4).
2. Align the holes in bottom tube the with hole in the
bagger frame.
3. Install the cotter pins (3) into holes and bend the
ends to secure to the frame.
4. Slide the frame assembly onto the grass bag (4).
5. Attach the bag clips to the frame assembly.
6. Align the bagger cover (5) to holes in frame.
7. Use screws (6) and (7) to assemble the side and
top of the cover to the bagger frame.
8. Assemble the bagger handle (8) thru hole in cover
and frame.
9. Secure the bagger handle with washer (9), screw
(10), and nut (11).
10. Install rear bagger handle (12) to cover using two
screws (13).
8
5/16
7
5
13
6
9
11
10
7/16
1
2
en
12
4
3
Figure 4