Attention; Introduction; Technical Details - Sagola XTech 100 Manual De Instrucciones

1. Attention

Before starting the unit you must read, take into consideration and comply with all the indications
described in this Manual.
This manual must be kept in a safe place, accessible to all users of the unit.
The unit must be started and handled exclusively by personnel instructed in its use and must be
employed only for the purpose for which it was designed.
Likewise, accident prevention standards, regulations, work centre directives and current legislation
and restrictions must be taken into consideration at all times.
The logotypes of SAGOLA and other SAGOLA products mentioned in this manual, are registered
trademarks or brand names of the company SAGOLA S.A.U.

2. Introduction

Your device belongs to the family of pneumatic double effect
airbrushes.
A versatile, high-quality airbrush that provides the professio-
nal artist with a demanding finish. A compact, efficient and
lightweight solution; Made of stainless steel and anodized
aluminum, which is designed so that you can spread color in
a certain area. But it is not just any painting, it could be said
that it has a similar finish to that of the aerosol or spray.
The equipment consists of the following:
_ Airbrush
_ Wrench

3. Technical details

XTech 100:
- Combination of nozzle and needle of 0.2 mm. (Ref.17410501)
- 0.9 c.c. (0.03 oz.) deposit to use with small quantity of paint.
- Made of stainless steel and anodized aluminum.
- Neddle closing and packing made of Teflon.
- Highly precise and smooth air and product valve.
- Working pressure: 1 - 2 bar (15 - 30 psi)
- Air inlet connection: 1/8" male
- Weight: 61.5 g.
XTech 200:
- Combination of nozzle and needle of 0.2 mm. (Ref.17410601) and 0.3 mm. (Ref.17410602)
- 1.5 c.c. (0.05 oz.) deposit to use with medium amounts of paint.
- Made of stainless steel and anodized aluminum.
- Neddle closing and packing made of Teflon.
- Highly precise and smooth air and product valve.
- Working pressure: 1 - 2 bar (15 - 30 psi)
- Air inlet connection: 1/8" male
- Weight: 69.7 g.
XTech 300:
- Combination of nozzle and needle of 0.3 mm. (Ref.17410701)
- 5 c.c. (0.16 oz.) deposit to use any paint quantity.
- Made of stainless steel and anodized aluminum.
- Neddle closing and packing made of Teflon.
- Highly precise and smooth air and product valve.
- Working pressure: 1 - 2 bar (15 - 30 psi)
- Air inlet connection: 1/8" male
- Weight: 96.5 g.
_ Air connector
_ Case
ENGLISH