Power Source Rear Panel Connector Description; Cooling Unit Interface; Description Of Display - Cebora KINGSTAR 400 TS Manual De Instrucciones

3�8�1

Power source rear panel connector description

For connectors CN1, CN2, CN3 and CN4 refer to section 9.4.
3�8�2 Cooling unit interface�
The following are present in the section relating to the cooling unit shown in figure 7:
U -
Shuko cooling unit socket maximum power 230 VAC 500 W
T -
Fuse holder fuse T 2 A/230 V – 0 5x20 mm
V
-Cooling unit pressure switch socket this socket manages the cooling unit pressure switch and unit
recognition.
Socket U is used exclusively to connect cooling unit GRV12 Item No 1683 to the welding power source�
Connecting other devices could affect the integrity of the welding power source or lead to operating
anomalies� CEBORA declines any responsibility for improper use of the power source and the accessories
connected to it�
3�9

Description of display

KINGSTAR robot power sources are equipped with resistive touchscreen LCDs with 7" diagonal (H) Fig. 7. A knob is
also present with rotary encoder and pushbutton (I) Fig. 7 for scrolling through the list parameters and confirming the
selected item.
70/109
Ethernet 100Mbit (LAN) connector
The connector is optional and present if the optional 24 VDC power
supply kit is present for external Wi-Fi router Item No 451.
CN5
Description
For more details, refer to the instruction manual of kit Item No 451 code
3301068.
CN5
1
2
WARNING
During start-up, for 5 seconds the display presents
all the information regarding the machine, the serial
number, the software version, when the software was
updated, the options installed and the IP address.
The display then presents the main screen (factory
setting).
Pin
+24 VDC 2 A
0 VDC
3301065/A