Arc Striking Modes; Lift Contact Ignition; Tig Parameter Settings Table - Cebora KINGSTAR 400 TS Manual De Instrucciones

5�3 Arc striking modes�
5�3�1 Lift contact ignition�
This type of ignition involves the electrode coming into contact with the welding workpiece. The starting sequence is
as follows:
1- Touch the workpiece to be welded with the electrode tip.
2- Press the torch trigger: a very low current now begins to circulate in the workpiece to be welded, which will
not spoil the electrode at the stage when it is detached from the workpiece.
3- Lift the electrode tip from the workpiece: the electric arc is now triggered, the required welding current begins
to circulate in the workpiece and the shielding gas flow is activated.
5�4 TIG parameter settings table�
Process parameters can be set directly using the following sequence:
♦
press I
♦
turn I to select a single parameter
♦
press I to enter parameter modification mode (the parameter turns red)
♦
turn I to set the desired value
♦
press I again to exit modification mode.
(*)
Item no� I2_max
372
374
80/109
Description
Preflow
EVO START
First Level Current
First Level Time
First Slope Time
Main Current
Setpoint
Final Slope Time
Crater Time
Crater Current
Postflow time
400 A
500 A
Min� DEF�
0.1 0.1
OFF OFF
3 25
0 0
0 1.0
3 100
0 1.0
0 0
3 10
0.1 10
Table 1
Max� UM
10 s
1.0 s
I_SET A
30 s
10 s
I2_max(*) A
10 s
10 s
I_SET A
50 s
Sol�
0.1
0.1
1
0.1
0.1
1
0.1
0.1
1
1 (0.1-25)
s
5 (25-50) s
3301065/A