Homewerks 7148-01-AX Manual Del Usuario página 8

INSTALLATION INSTRUCTIONS (Continued)
10. Slide the duct connector (F) into the tabs on the fan housing
(A) until the duct connector (F) snaps firmly into place over
the opening in the fan housing (A).
NOTE: Remove the protective tape on the duct adapter (F)
flap.
11. Install the wall switch according to the wiring diagram on page 5.
Remove the wiring box cover from the fan housing (A). Pull the
house wires through the hole in the wiring box cover. Using the
quick connectors, connect the house wiring to the wall switch
(G) and fan housing (A). 14 AWG is the smallest conductor
that should be used for branch circuit wiring. Please refer to
the wiring diagram on page 5 to ensure proper wire connections
are made. Carefully push the wire connections into the wiring
box and reattach the wiring box cover.
NOTE: Do not use metal wall plate with the wall switch (G), as it
may cause interference with the fan operation.
CAUTION: The switch included with this ventilation fan requires
a neutral wire connection. If a neutral line is not present, one
must be run by a qualified electrician. If you require assistance,
please call 1-877-319-3757 before attempting switch installation.
CAUTION: This switch is intended to only operate with this
bath fan. Connections to other electrical fixtures are prohibited
and could cause electrical issues.
12. Connect a 4 in. circular duct to the fan housing (A), securing
it with duct tape or a clamp. Vent the duct to the outside.
13. Join the connectors from the fan housing (A) to the grille (B).
The grille (B) must be connected BEFORE turning on power
to the fan.
14. Attach the grille (B) by pinching the mounting springs and
inserting them into the narrow rectangular slots in the fan
housing (A).
Turn on the power source. Test the unit.
10
11
A
12
A
13
B
14
Slots in fan
housing
8
F
A
Quick
connector
A
3-hole
4-hole
A
Mounting
springs
5-hole
B
Homewerks.com