Preliminary Controls; Forward And Reverse Movement Operations; Lifting And Lowering Operations - Pegasolift T14 Guía Para El Uso Y El Mantenimiento

PUTTING IN FUNCTION AND PALLET TRUCK UTILIZATION

PRELIMINARY CONTROLS:

The stacker ready to use must be in the following conditions:
1) Battery charger plug: disconnected.
2) Start key: activated.
3) Tiller bar: in vertical position
4) Lifting group: completely lowered.

FORWARD AND REVERSE MOVEMENT OPERATIONS:

FORWARD
movement: turning in the sense of watch needles the stacker moves forward, in the
contrary sense the pallet truck moves reverse.
Controlling in an adequate manner the turning there it is easy to control the pallet truck
speed.
It is advised to avoid abrupt and repeated starts and slowing down in order to avoid
overheating of the motor and rapid discharge of the battery.

LIFTING AND LOWERING OPERATIONS

1) Introduce the forks in the lower part of the pallet on which the load is put with
maximum of care and minimum speed; it is recommended for a bigger stability of
the load to introduce completely the forks (see page 10 "Transport of load").
2) Control that the load is equally distributed on the forks and the positions of the
barycenter is within the limits shown by the arrow on the stacker.
3) For lifting: keep pushing the button for lifting (reference page 12 "Tiller head" no. 4)
until the desired height is achieved.
4) For lowering: keep pushing the button for descent (reference page 12 "Tiller head"
no. 4) until the desired height is achieved.
ATTENTION!
executed only with the pallet truck completely stopped.
BACKWARD
The load lifting and lowering operations should be
C 16
48
1) Introduce the start key.
2) Push simultaneously with
both hands the tiller head
and bring it in a quite
horizontal position: in fast
gear mode the positions
completely horizontal and
vertical forbid the forward
and reverse movement .
3) Operate the butterfly
c o n t r o l b u t t o n s f o r