Honeywell COMFORT TEMP 4 HCE640 Serie Manual Del Usuario página 5

SAFEGUARD® MOTION SENSOR FEATURE (HCE645 Series only)
The Honeywell ComfortTemp™ 4 Ceramic Heater (Model series HCE645 only) is equipped with a SafeGuard®
Motion Sensor feature. This motion sensor feature identifies objects that may obstruct the normal flow of heat
from the unit, shutting the unit off when necessary, for an additional level of protection.
How It Works: If an object remains too close to the front of the heater for too long - 6 inches or closer for more
than a few seconds - the Motion Sensor light on the front of the unit (Fig. 5) will blink as a warning that there is an
obstruction. If the object is not removed, the sensors will disable the heat, turning the heater off until the object
is removed. The heater will restart after a few seconds once the object is removed.
• Press the SafeGuard® Motion Sensor Button (
Fig.5
SafeGuard® Motion Sensor Light
REMOTE CONTROL (HCE643 and HCE645 Series only)
The Honeywell ComfortTemp™ 4 Ceramic Heater (Model Series HCE643
and HCE645 only) can be controlled using the remote (Fig. 7). This remote
uses a button cell type battery which comes included in the remote.
• To activate the battery, simply pull the plastic tab.
• All functions may be controlled with the remote with the exception
of choosing which operational mode you prefer (Auto Shut-Off or
Continuous Heating). This must be done manually using the red switch
on the back of the unit.
• Place remote control in the holder located in the handle area in the back of
the heater when not in use.
) (Fig. 6) to turn this feature on or off.
Fig. 6
5
SafeGuard® Motion Sensor Button
Fig. 7
Remote Control